Complete
data projection systems are available in several classrooms on the Naperville
campus. These systems are permanently mounted in the classroom, and allow
the user to display computer data on a large screen without setting up equipment.
Click here to find classrooms with ceiling mounted data projection systems
To reserve a classroom with this equipment, contact the
Registrar at 637-5252.
To use the ceiling mounted data
projection system, follow these directions:
1. Turn on computer and monitor using the appropriate power buttons.
2. Turn on the data projector's remote control unit by sliding the on/off switch located on the side of the remote.
3.
Make sure the remote is set to Adj, not mouse. Turn on the
data projector using the remote
control's on button. Point the remote at the projector or screen.
The data projector is set to fit the screen and is focused, no further adjustment should be necessary.
*In the unlikely event the projected image is interrupted by horizontal lines of static, the refresh rate on the computer must be reset. Click here for instructions on setting the refresh rate.
Shut down procedures
A. Exit all computer programs and follow the normal Windows 95 shut down process.
B. Using the data projector remote control, press the off switch.
C. Turn
off computer and monitor using the appropriate power switches.
|
|
|
|
Need additional help with
the ceiling mounted data projection system?
See the Troubleshooting
Guide
Instructional Media Equipment Directions Index
Return to the Instructional Media Home Page
Revised 09-06
Send comments about this page to Tom Gill, Instructional Media
Coordinator tmgill@noctrl.edu